User Manual Q&AAnswer
Feb 24, 2025 - 07:36 AM
To add or delete users using the admin cards, follow these steps:
1. Make sure the device is in standby mode (indicated by a red light).
2. To add users:
a. Read the "Admin Add Card" by swiping it in front of the device.
b. Read the user cards one by one to add them to the system.
c. Repeat step 2b for additional user cards.
d. Finally, read the "Admin Add Card" again to end the process.
3. To delete users:
a. Read the "Admin Delete Card" by swiping it in front of the device.
b. Read the user cards one by one to delete them from the system.
c. Repeat step 3b for additional user cards.
d. Finally, read the "Admin Delete Card" again to end the process.
Note: The admin cards are used to initiate the adding or deleting process. Make sure to follow the correct sequence and use the designated admin cards for each operation.
For more detailed instructions and illustrations, please refer to the Dioche A7 Stand Alone Access Control and Reader User Manual.
Add New Comment