User Manual Q&AAnswer
Feb 24, 2025 - 07:10 AM
To set the mode on the elero Aero-868/915 Plus Radio Sensor for Light and Wind, follow these steps:
1. Locate the multi-way switch for setting the mode on the underside of the Aero-868/915 Plus.
2. Use a small screwdriver to set the multi-way switch to the "Function" position.
3. Press and hold the UP and DOWN buttons on the unit for at least 3 seconds.
4. Pressing the two buttons again will switch to the next mode.
5. The current mode is indicated by the flashing of the transmission LED. The LED will flash once for awning mode, twice for visual protection mode (only with Aero-868/915 Plus), and three times for roller shutter mode (only with Aero-868/915 Plus).
6. Set the multi-way switch back to the desired wind value.
Note: The default mode of the Aero-868/915 Plus is awning mode. You can switch through the modes in sequence by following the steps above.
Add New Comment