User Manual Q&AAnswer
Feb 24, 2025 - 07:04 AM
To wire the zencontrol zc-smart-relay Inline Relay, please follow these steps:
1. Ensure that the electrical supply is turned off and isolated before starting the installation.
2. Release the two end covers of the relay using a flatblade screwdriver.
3. Mount the relay driver in the desired location.
4. Wire the relay according to the provided wiring diagram.
5. Replace the end covers to ensure adequate strain relief.
6. Note that the relay must have an appropriate MCB (Miniature Circuit Breaker) to protect the load circuit.
Please refer to the product manual for the specific wiring diagram and additional information on wire preparation and installation.
It is important to note that this product should only be installed by a licensed electrician, and compliance with relevant building and safety codes is the responsibility of the installer. For more detailed information and compliant software, you can visit the zencontrol website at zencontrol.com.
Add New Comment