User Manual Q&AAnswer
Feb 24, 2025 - 06:27 AM
To install the FRACARRO Cascadable 9 Inputs Switches with Active and Passive TV Gain, follow these steps:
1. Use the provided plastic brackets to install the switch. Refer to the instruction manual for the correct installation position.
2. Connect the earthing xxxx to ensure proper grounding.
3. Connect the power supply to the DC port located at the bottom left side of the switch. It is important to use only the optional PSU (PSU1215TS or PSU1340TS) as using an incorrect voltage (e.g., 18V) can damage the product. The switch can also be powered by trunk lines, but the voltage must be within 12V and 14V. Using a higher voltage (e.g., 18V) will damage the switch.
4. Once the switch is correctly powered, the voltage will be sent to all input satellite ports, allowing you to feed the connected LNBs or amplifiers.
Note: The TV signal can be adjusted using the dip switch on the top right side of the switch. When the TV gain is passive, it is not necessary to feed the switch, and there is also the return channel.
For more detailed instructions and illustrations, please refer to the product's instruction manual.
Add New Comment