User Manual Q&AAnswer
Feb 24, 2025 - 06:25 AM
To assemble and mount the Clarke CBB250 250MM Buffer-Polisher, follow these steps:
1. Mounting the Machine:
- Bolt the buffer/polisher to a workbench using the securing holes provided.
- Ensure that the ventilation paths through the base are not blocked.
- Check that the installation is secure before turning the buffer on.
2. Fitting Buffing/Polishing Pads:
- Place the spacer over the shaft.
- Place the polishing mop between the washers and secure it with the retaining nut, hand tight.
- The shaft threaded ends are handed LH (left-hand) and RH (right-hand).
- Tighten the nuts enough to grip without crushing the buffing/polishing pad.
- Note: Wheel rotation, when in use, will tighten the retaining nut.
3. Using Your Buffer/Polisher:
- Plug the buffer/polisher into the mains power supply.
- Switch the buffer/polisher on.
- Slowly bring the workpiece into contact with the polishing mop.
- Ensure contact with the wheel is made within the designated quadrant (as shown in the manual).
- Do not contact the wheel outside of the quadrant.
- After use, unplug the buffer/polisher from the mains power supply and clean the machine for the next use.
Please refer to the manual for detailed instructions and illustrations on the assembly and mounting process.
Add New Comment