User Manual Q&AAnswer
Feb 24, 2025 - 06:24 AM
To replace the outer spatter lens on the ESAB Savage A40 Air Welding Helmet, follow these steps:
1. Ensure that the helmet is always equipped with an Outside Lens (before the filter, on the outside of the helmet) and an Inner Lens (behind the filter, inside the helmet). These protection lenses must be replaced if broken, damaged, or covered with welding spatter to such an extent that vision is impaired.
2. Inner & Outer Lenses are consumables and must be replaced regularly with certified ESAB spare parts (CE marked).
3. Before using the Savage A40 helmet for the first time, the protective films must be removed from the Front Spatter Lens. The films cannot be removed from the Front Spatter Lens with the Lens in place. Please follow the instructions below to remove the Spatter Lens.
4. To insert the new outer protection lens, the filter must be removed by unscrewing the two retaining screws from the inside of the helmet.
5. Remove the old protection lens and insert the new lens.
6. Place the light seal cradle, ADF, inner protection lens, and ADF retaining frame back in place.
7. Replace the two retaining screws to secure the filter.
Note: It is important to use certified ESAB spare parts for replacement and to follow the instructions provided in the manual for proper maintenance and care of the welding helmet.
Add New Comment