User Manual Q&AAnswer
Feb 24, 2025 - 06:19 AM
To adjust the depth of cut on the RYOBI P2300 18 Volt Edger, follow these steps:
1. Remove the battery pack from the edger.
2. Lift the depth adjustment lever located on the side of the edger.
3. Move the lever up to increase the depth of cut or down to decrease the depth of cut.
4. Release the lever to lock it into the desired position.
5. Reinstall the battery pack.
Note: The blade depth can be adjusted from 1/4 inch to 1-1/2 inches. It is recommended to start with a depth of 1/2 inch and make shallow cuts to test the cutting depth. Adjust as needed until the desired depth is achieved.
Please refer to the operator's manual for more detailed instructions and safety precautions.
Add New Comment