User Manual Q&AAnswer
Feb 24, 2025 - 06:10 AM
To assemble the Crosby Group SS-4055 Stainless Steel Hook Latch Kit, please follow these steps:
1. Start by inspecting the hook and latch before use. Ensure that the latch is not distorted or bent.
2. Make sure the spring will force the latch against the tip of the hook.
3. Always ensure that the hook supports the load, and the latch should never support the load. Refer to Figures 1 and 2 in the manual for visual guidance.
4. When placing two sling legs in the hook, ensure that the angle between the legs is small enough and that the legs are not tilted, so nothing bears against the bottom of the latch. Refer to Figures 3 and 4 for reference.
5. It's important to note that the latches are designed to retain loose slings or devices under slack conditions and are not intended to be used as an anti-fouling device.
6. Please be aware that loads may disengage from the hook if proper procedures are not followed, which can result in serious injury or death. Refer to OSHA Rule 1926.1431(g)(1)(i)(A) and 1962.1501(g)(4)(iv)(B) for more information.
7. This particular hook and latch combination should not be used for lifting personnel.
8. Always read and understand the instructions provided before using the hook and latch.
Now, let's move on to the specific instructions for assembling the Model SS-4055 latch on Crosby hooks:
1. Place the hook at approximately a 45-degree angle with the cam facing up.
2. Position the coils of the spring over the cam, ensuring that the tines of the spring point toward the point of the hook. The loop of the spring should be positioned down and lying against the hook.
3. Position the latch over the tines of the spring, with the ears partially over the hook cam. Swing the latch to one side of the hook, point, and depress the latch and spring until the latch clears the point of the hook.
4. Line up the holes in the latch with the hook cam.
5. Insert the bolt through the latch, spring, and cam.
6. Tighten the self-locking nut on one end of the bolt.
Please note that these instructions apply specifically to the Crosby Group SS-4055 Stainless Steel Hook Latch Kit. Always refer to the manual provided for complete and accurate assembly instructions.
Add New Comment