User Manual Q&AAnswer
Feb 24, 2025 - 05:50 AM
To insert and change the bandsaw blade on the HILTI NURON SB 4-22 Portable Band Saw, follow these steps:
1. Slacken the 2 screws securing the blade cover and remove the cover.
2. Turn the side handle counterclockwise to unscrew it from the casing of the bandsaw.
3. Pivot the clamping lever through 180° in the direction of rotation until it is seated against the stop.
4. Slip the bandsaw blade into the cutting guide and into the blade guides, one after the other. The back of the blade must touch the bearings in the bottom of the blade guides.
5. Note the direction of rotation indicator arrows on the bandsaw blade and the bandsaw. They must point in the same direction.
6. Slip the bandsaw blade over both rollers, one after the other.
7. Pivot the clamping lever through 180° in the direction of rotation until it is seated against the stop.
8. Check that the bandsaw blade tool is correctly guided over both rollers.
9. Refit the blade cover. Make sure that the cover is correctly seated.
10. Install the side handle.
Please refer to the HILTI NURON SB 4-22 Portable Band Saw User Guide for illustrations and additional information on the bandsaw blade installation process.
Add New Comment