How do I install the ESAB Rogue ET 180i or ET 200iP PRO welding machine? (ESAB ROGUE ET 180i ET 200iP PRO Instructions)

Answer

manuals.plus

Feb 24, 2025 - 05:23 AM

To install the ESAB Rogue ET 180i or ET 200iP PRO welding machine, follow these steps:

1. Ensure that the power supply is compatible with the machine's requirements. The input voltage and frequency should match the specifications mentioned in the manual.

2. Connect the machine to the power supply using the appropriate power cable. Make sure the power switch is in the "OFF" position before connecting.

3. Connect the work cable to the workpiece or the work clamp. Ensure that the connection is secure and clean for optimal welding performance.

4. Connect the electrode holder or torch to the machine. Again, ensure that the connection is secure and clean.

5. Check the gas supply if you are using a gas-shielded welding process. Make sure the gas cylinder is properly connected and the flow rate is set according to the recommended values.

6. Once all connections are made, turn on the power switch and set the desired welding parameters using the control panel. Refer to the manual for guidance on adjusting the settings based on your welding requirements.

7. Before starting any welding operation, it is important to read and understand the safety precautions mentioned in the manual. Ensure that you are wearing appropriate personal protective equipment (PPE) and follow safe welding practices.

For more detailed instructions and illustrations, please refer to the ESAB Rogue ET 180i, ET 200iP PRO instruction manual available at http://manuals.esab.com/. If you have any further questions or need assistance, you can also contact ESAB directly through their website at esab.com or by phone at +46 (0) 31 50 90 00.