How do I install the Breckwell SP22 Pellet Stove Maverick? (BRECKWELL SP22 Pellet Stove Maverick Owner's Manual)

Answer

manuals.plus

Feb 24, 2025 - 05:00 AM

The installation process for the Breckwell SP22 Pellet Stove Maverick involves several steps. Here is a general overview of the installation process:

1. Prepare the area: Clear the area where you plan to install the stove and ensure there is proper clearance from combustible materials.

2. Choose the installation type: Determine whether you will be installing the stove as a freestanding unit, a fireplace insert, or in a mobile home. Each installation type has specific requirements.

3. Install floor protection: If installing the stove as a freestanding unit, place it on a noncombustible material such as ceramic tile or cement board to protect the floor.

4. Determine venting requirements: Decide on the venting configuration based on the installation type. The stove can be vented horizontally through a wall, vertically through a chimney, or vertically into an existing masonry fireplace.

5. Assemble the stove: If using a pedestal or leg set, follow the instructions provided to assemble it. Attach the circuit board/control panel to the stove as instructed.

6. Install the venting system: Follow the instructions provided by the vent manufacturer to install the venting system. Ensure all connections are secure and airtight using appropriate clamps and tape.

7. Connect to electrical outlet: Plug the stove's grounded electrical cord into a standard 120V, 60Hz electrical outlet. Do not use an adapter plug or sever the grounding plug.

8. Secure the stove (for mobile home installation): If installing the stove in a mobile home, it must be properly secured to the floor using lag bolts. Consult local codes for specific requirements.

9. Perform a pre-startup check: Before starting the stove, remove the burnpot and clean it, clean the firebox, and check the fuel level in the hopper.

10. Start the stove: Press the "On/Off" button to start the stove. The igniter will stay on for about 10-15 minutes until the fire is established. Adjust the feed rate and damper control as needed.

Please note that these are general instructions, and it is important to refer to the Breckwell SP22 Pellet Stove Maverick Owner's Manual for detailed installation instructions specific to your model.