How do I pair multiple receivers with a single transmitter for the Armacost Wireless Light Switch Remote? (Armacost Wireless Light Switch Remote Instruction Manual)

Answer

manuals.plus

Feb 24, 2025 - 04:49 AM

To pair multiple receivers with a single transmitter, follow these steps:

1. Plug the receivers into separate 120V AC electrical outlets.
2. Test each receiver by plugging an electrical device, such as a lamp, into the outlet located at the bottom of the unit. Make sure the devices are powered ON.
3. On the transmitter switch, push the button in the middle to turn the device ON or OFF.
4. If the receivers do not respond to the transmitter, they need to be paired.
5. Press and hold the ON/OFF button on one of the receivers for 10 seconds. The LED indicator on the receiver will begin to flash rapidly.
6. Press the transmitter button twice.
7. The receiver and transmitter are now paired. Repeat steps 5-7 for each additional receiver you want to pair with the transmitter.
8. Each receiver can have up to two transmitters paired to it, and each transmitter can control up to four receivers.

Note: If you want to unpair a transmitter from a receiver, press and hold the ON/OFF button on the receiver for 3 seconds. The LED indicator will begin to flash rapidly, indicating that the unpairing procedure has started. This will unpair all transmitters from that receiver.

If you encounter any issues during the pairing process, make sure the battery in the transmitter is fresh, move the transmitter closer to the receiver, and try re-pairing the transmitter to the receiver. If the problem persists, you can contact Armacost Lighting's customer support at support@armacostlighting.com for further assistance.