Answer

Feb 24, 2025 - 03:55 AM
To wire the buttons and joysticks to the PACTO 4000H interface, you will need to connect one side of each button and joystick to the ground. The directions for wiring make more sense when looking at your panel upside down. The leftmost position on the interface should be wired to the P1 inputs, and then increment up as you move to the right. It is recommended to follow the wiring diagram provided in the manual, even if you prefer to keep the controls as 3,1,2,4. The default player order is 3124, which is commonly used for 4 player arcade cabinets. The "pinball" inputs for RB, LB, and A are always mapped to player 1, unlike the others which may change position depending on the mode selected.
Please refer to the manual for the specific pinout and wiring details.
Add New Comment