User Manual Q&AAnswer
Feb 24, 2025 - 03:48 AM
To connect the ELATION MSR912 MagRF Wireless Module and Remote Control to your amplifier, please follow these steps:
1. Make sure your amplifier is compatible with the mains electricity supply. If you are unsure, seek help from a qualified technician or consult your Marshall dealer.
2. Check the mains input voltage rating indicated on the rear panel of your amplifier. Use a detachable mains (power) lead to connect it to the mains input socket on the rear panel.
3. Ensure that the correct value and type of mains fuse is specified on the rear panel. Never bypass the fuse or use an incorrect value or type.
4. When using the Origin amplifier with an extension speaker cabinet(s), ensure that the speaker cabinet(s) is connected to the correct loudspeaker jack socket(s). Refer to sections 3.1, 3.2, and 3.3 of the manual for specific information.
5. Use a proper speaker cable to connect the speaker cabinet. Do not use a screened (shielded) guitar cable for this purpose.
6. Set the power switch to the off position (front panel function 2.1).
7. Connect the supplied mains (power) lead into the mains input on the rear panel first, and then into an electricity outlet.
8. Set the volume controls on the front panel to zero.
9. Plug your guitar into the input jack socket on the front panel.
10. Select either high, mid, or low power (front panel function 2.2).
11. Turn on the front panel switch and wait a couple of minutes for the amplifier to warm up.
12. Gradually increase the volume to your preferred level, and your amplifier is ready to play.
Please note that these instructions are a general guide. For more detailed information and specific instructions, refer to the ELATION MSR912 MagRF Wireless Module and Remote Control User Manual
Add New Comment