User Manual Q&AAnswer
Feb 24, 2025 - 12:57 AM
The installation environment requirements for the DEPRAG D52-ADC Digital Milling Machine are as follows:
1. Equipment size:
- Workshop door size: The minimum opening size of the workshop door must be greater than 850mm to allow the equipment to enter.
2. Table for installing equipment:
- Table size requirements: The table should have a length of 870mm, width of 780mm, and height of 700mm. The length and width should not be less than the specified dimensions.
- Table load-bearing requirements: The table should be able to bear a load of more than 300KG.
- Table flatness requirements: After placing the table on the ground, the upper surface must be flat and stable without any shaking.
3. Power supply requirements:
- Voltage requirements: The machine requires AC220V 50HZ power supply.
- Power requirements: The power socket should have a power greater than 2KW.
- There should be a power socket within 1 meter of the rear end of the device, and proper grounding must be ensured.
4. Air pressure requirements:
- Flow requirements: The gas flow connected to the gas pipe of the cutting machine must be greater than 95L/min and continuously stable.
- Pressure requirements: The air pressure connected to the air pipe of the milling machine should be kept above 0.6 MPa and stable.
- The compressed gas used by the machine should be dried to prevent damage to the spindle.
- The total air source of the milling machine is connected to the external air pressure using an 8mm diameter air pipe.
5. Networking requirements:
- Customers accessing the external network need to confirm in advance whether the network is a dynamic address or a static address. If it is a static network, it is necessary to contact the network administrator to confirm the gateway information.
- Ensure that the internet cable accesses all IPs and works once connected to computers.
- Users without network requirements can skip this step.
6. Vacuum cleaner requirements:
- Customers who bring their own vacuum cleaners need to ensure that the diameter of the vacuum cleaner matches the diameter of the vacuum pipe of the equipment, which is 40mm.
7. Software requirements:
- Customers need to purchase typesetting software. The DEPRAG D52-ADC Digital Milling Machine is an open typesetting system that supports typesetting software such as mailbox, hyperdense, work, etc.
Please refer to the DEPRAG D52-ADC Digital Milling Machine User Manual for more detailed information and instructions on installation and usage.
Add New Comment