User Manual Q&AAnswer
Feb 24, 2025 - 12:19 AM
To install the HANECO VSL20W06-TRI Indoor LED Batten Range, please follow these steps:
1. Switch off the power: Before starting the installation, make sure to turn off the power to the area where you will be installing the LED batten.
2. Remove the diffuser: Take off the diffuser from the LED batten. The manual does not provide specific instructions on how to remove the diffuser, but it should be detachable for easy installation.
3. Connect the wires: Ensure that the input voltage of the LED batten matches the specifications mentioned in the manual. Connect the wires securely according to the wiring diagram provided in the manual.
4. Fasten the chassis to the surface: Securely fasten the LED batten's chassis to the desired surface using appropriate screws or mounting brackets. Make sure the chassis is firmly attached.
5. Fasten the diffuser to the chassis: Once the chassis is securely mounted, reattach the diffuser to the LED batten. Ensure that it is properly aligned and firmly attached.
6. Switch on the power: After completing the installation, switch on the power to test the LED batten. Ensure that all wires are correctly connected and that the LED batten is functioning properly.
Please note that these installation instructions are general guidelines. It is essential to have a licensed electrician perform the installation to ensure compliance with relevant Australian standards and local regulations. Failure to follow the instructions may void the warranty.
For more detailed information or if you have any further questions, you can contact Haneco customer service at (08)8297 6373 or visit their website at www.haneco.com.au.
Add New Comment