User Manual Q&AAnswer
Feb 23, 2025 - 11:11 PM
To assemble the onnline 2 Bowl Kitchen Water Trap, please follow the steps below:
1. Start by ensuring you have all the necessary components from the packaging, including the water trap body, rubber gaskets, and nuts.
2. Place the rubber gasket on the bottom of the water trap body. This gasket will create a watertight seal between the trap and the sink.
3. Insert the water trap body into the sink drain hole. Make sure it fits securely and is centered.
4. From underneath the sink, place another rubber gasket on the threaded section of the water trap body. This gasket will create a seal between the trap and the sink drain pipe.
5. xxxx on the nut provided onto the threaded section of the water trap body. Tighten the nut securely by hand.
6. Connect the other end of the water trap body to the sink drain pipe. Ensure it is aligned properly and tighten the nut securely by hand.
7. Check for any leaks by running water through the sink. If there are any leaks, tighten the nuts further until the leak stops.
Please note that these instructions are general guidelines, and it is always recommended to refer to the specific instruction manual provided with the product for more detailed and accurate information.
Add New Comment