User Manual Q&AAnswer
Feb 23, 2025 - 11:07 PM
To install the filters on the Milwaukee M18 Fuel 9 Gallon Dual Battery Wet Dry Vacuum, follow these steps:
1. Remove the battery packs from the vacuum.
2. Release the tank latches and lift off the motor housing. Place it upside down on a flat surface.
3. To remove the filter, turn it 1/2" counter clockwise and pull it off of the motor housing/float cage.
4. Empty all debris from the tank.
5. To install the filter, slide it over the float cage. Line up the filter tabs with the motor housing notches and turn it 1/2" clockwise to lock in place.
6. Replace the motor housing and secure both latches.
It is important to ensure that the filters are properly installed before using the vacuum. The high efficiency filter should be used for dry pickup only, while the foam filter should be used for wet pick-up operation only.
Add New Comment