How do I install the Thomas Betts EC002656 Code Keeper Weatherproof While-in-Use Cover? (Thomas & Betts EC002656 Code Keeper Weatherproof Cover User Guide)

Answer

manuals.plus

Feb 23, 2025 - 11:06 PM


To install the Thomas Betts EC002656 Code Keeper Weatherproof While-in-Use Cover, please follow the steps below:

1. Ensure that the power is turned off at the circuit breaker before starting the installation process.

2. Locate the electrical box where you want to install the cover. The Code Keeper Weatherproof While-in-Use Cover is designed for vertical mount weatherproof GFCI receptacle boxes.

3. Remove the existing cover from the electrical box, if applicable.

4. Position the Code Keeper Weatherproof While-in-Use Cover over the electrical box, aligning the  xxxx  holes with the holes on the electrical box.

5. Insert the screws provided with the cover through the  xxxx  holes and into the corresponding holes on the electrical box.

6. Using a screwdriver, tighten the screws until the cover is securely attached to the electrical box.

7. Ensure that the cover is properly sealed to provide weatherproof protection. If necessary, apply a silicone sealant around the edges of the cover to create a watertight seal.

8. Once the cover is securely installed, you can proceed to connect and use your electrical devices while keeping them protected from the elements.

Please note that this is a general guide for installing the Thomas Betts EC002656 Code Keeper Weatherproof While-in-Use Cover. For specific instructions and safety precautions, it is recommended to refer to the user guide or contact the ABB Installation Products Technical Support mentioned in the product information.