Answer

Feb 23, 2025 - 10:58 PM
To set the shaking speed and time on the Labnet Orbit Digital Shakers, follow these steps:
1. Press the POWER switch on the control panel to turn on the shaker. The display will show the set time and the Time light will illuminate.
2. Rotate the ENCODER xxxx right (+) or left (-) to select the desired shaking time. The set time can be selected from 30 seconds to 99 minutes and 50 seconds. For example, 99.5 represents 99 minutes and 50 seconds, 9.59 represents 9 minutes and 59 seconds, and 0.30 represents 30 seconds.
3. If you want to set the timer to hold, turn the ENCODER xxxx left or right until "HLd" is displayed. This function can be accessed by setting the time to under 0.30 or above 99.5.
4. Push down on the ENCODER xxxx to switch to RPM set mode. The RPM light will illuminate.
5. Rotate the ENCODER xxxx right (+) or left (-) to select the desired shaking speed in RPM (revolutions per minute). The available range of RPM depends on the model of the shaker.
6. Press the START/STOP button to start the operation. The RUN and TIME lights will illuminate, and the shaker will run for the set time and at the set speed.
Note: The set time cannot be modified during shaking. If you need to change the time, you can stop the shaker with the START/STOP button and then reset the time.
If you want to view the set value for RPM or time during shaking, rotate the ENCODER xxxx for one click right (+) or left (-). The corresponding light will flash for 2 seconds, and the display will show the set value.
Add New Comment