How do I connect and set up the PERASO 60GHz mmWave Modules? (PERASO 60GHz mmWave Modules User Guide)

Answer

manuals.plus

Feb 23, 2025 - 10:48 PM

To connect and set up the PERASO 60GHz mmWave Modules, please follow the steps below:

1. Hardware Setup:

- Connect the module to your device using the USB 3.0 data and control interface.

- Ensure that the module is powered by a single 5V power supply input.

- Make sure the module is placed in an appropriate location for optimal signal strength.

2. Software/Firmware Installation:

- Install the appropriate software/firmware version for your application. Peraso offers a variety of software/firmware versions optimized for common applications.

- Follow the installation instructions provided with the software/firmware package.

3. Configuration:

- Once the software/firmware is installed, you can configure the module for your specific needs.

- Refer to the user guide or documentation provided with the software/firmware package for detailed instructions on configuring the module.

- You may need to adjust settings such as channel selection, beamforming, and encryption.

4. Testing and Troubleshooting:

- After the module is configured, perform testing to ensure proper functionality.

- Use the provided software/firmware tools to monitor and troubleshoot any issues that may arise.

- If you encounter any difficulties, refer to the troubleshooting section in the user guide or contact Peraso support for assistance.

Please note that the above steps provide a general overview of the setup process. For detailed instructions and specific configurations, it is recommended to refer to the PERASO 60GHz mmWave Modules User Guide provided by Peraso Inc.