How do I install the GTS RaceChip on my car? (GTS RaceChip Owner's Manual)

Answer

manuals.plus

Feb 23, 2025 - 10:09 PM

The installation process for the GTS RaceChip is straightforward and can be done by following these steps:

1. Start by locating the engine control unit (ECU) in your car. The ECU is usually found in the engine compartment, but the exact location may vary depending on the make and model of your vehicle.

2. Disconnect the battery to ensure safety during the installation process.

3. Remove the ECU cover to gain access to the wiring harness. Carefully disconnect the wiring harness from the ECU.

4. Connect the wiring kit provided with the GTS RaceChip to the corresponding connectors on the ECU. Ensure that the connections are secure and properly aligned.

5. Mount the GTS RaceChip module in a suitable location near the ECU. The module should be placed in a position where it is protected from moisture and excessive heat.

6. Use the provided fixing clips and cable ties to secure the wiring and module in place. Make sure that the cables are neatly arranged and do not interfere with any moving parts or hot surfaces.

7. Reconnect the battery and start the engine to test the installation. The LED display on the GTS RaceChip module should light up, indicating that it is functioning properly.

8. Fine-tune the GTS RaceChip to match your engine's performance and characteristics. Refer to the user's manual for instructions on how to adjust the fine-tuning mappings using the LED display.

9. Once the fine-tuning is complete, take your car for a test drive to experience the enhanced performance and fuel savings provided by the GTS RaceChip.

Please note that this answer is a general guideline for the installation process. It is always recommended to refer to the specific instructions provided in the GTS RaceChip owner's manual for your particular vehicle model.