Answer

Feb 23, 2025 - 10:08 PM
To install the Generation Lighting Dearborn Flush Mount, please follow these steps:
1. If necessary, xxxx the shorter end of the threaded xxxx tightly onto the mounting plate.
2. Secure the mounting plate to the junction box.
3. Connect the fixture to a suitable ground in accordance with local electrical codes.
4. Connect the white fixture wire (square and/or rigid) to the neutral power line wire using a wire nut.
5. Connect the black fixture wire (round and/or smooth) to the hot power line wire using a wire nut.
6. Properly tuck the wires into the junction box.
7. Place the fixture base and washers onto the threaded xxxx and secure them in place by screwing the hex nut onto the threaded xxxx . Also, xxxx the knurled nut onto the threaded xxxx .
8. xxxx the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
9. Install the shade to the fixture and secure it in place using the shade screws.
Please note that these instructions are a general guideline and may vary depending on your specific installation requirements. It is important to consult the applicable installation code and have a person familiar with the construction and operation of the product perform the installation to ensure safety and compliance.
Add New Comment