User Manual Q&AAnswer
Feb 23, 2025 - 10:03 PM
To install the INFINITY WiFi Module for Proteous Range, follow these steps:
1. Disconnect the power supply to the control unit.
2. Insert the module into the ADI port of the control unit.
3. Ensure that the module is in access point mode by checking if the LED is steadily red.
4. Proceed to enroll the control panel to the server by following the instructions provided by the V2 GO APP.
If the module is not in access point mode, you can reset it using the reset procedure. Press the reset button for 3 seconds until the LED goes out and lights up again, remaining steadily red.
Please refer to the user manual for more detailed instructions and troubleshooting information.
Add New Comment