User Manual Q&AAnswer
Feb 23, 2025 - 09:58 PM
The onninen EN274 Kitchen Water Trap is designed to effectively trap and remove waste water from your kitchen sink. Here is a step-by-step guide on how to install it:
1. Start by ensuring that you have all the necessary tools and materials for installation, including a wrench, plumber's tape, and the onninen EN274 Kitchen Water Trap.
2. Before installation, make sure to turn off the water supply to your sink. This can usually be done by shutting off the main water valve.
3. Remove the existing water trap, if applicable, by loosening the nuts connecting it to the sink drain and the waste pipe. Use a wrench to loosen the nuts and carefully detach the old trap.
4. Clean the sink drain and waste pipe thoroughly to remove any debris or residue.
5. Take the onninen EN274 Kitchen Water Trap and apply plumber's tape to the threaded ends of the trap. This will help create a watertight seal.
6. Attach one end of the trap to the sink drain by screwing it on clockwise. Make sure it is securely tightened, but be careful not to overtighten as this may damage the threads.
7. Connect the other end of the trap to the waste pipe by aligning the threads and screwing it on clockwise. Again, ensure it is securely tightened without overtightening.
8. Once the trap is securely attached, turn on the water supply and check for any leaks. If you notice any leaks, tighten the connections further or consider using plumber's tape for a better seal.
9. Finally, run water through the sink to test the trap's functionality. Check for proper drainage and ensure that the trap effectively captures and removes waste water.
Please note that this is a general installation guide, and it is always recommended to refer to the specific instructions provided in the onninen EN274 Kitchen Water Trap Instruction Manual for detailed installation steps and any additional precautions.
Add New Comment