User Manual Q&AAnswer
Feb 23, 2025 - 09:08 PM
To adjust the hangar bar length for the NICOR DLR56 (v5) 5-6-inch White Recessed LED Downlight System, follow these steps:
1. Carefully unpack the frame from its packaging and inspect it for any defects due to shipping.
2. If necessary, adjust the hangar bar length by separating the bars and snapping them to the desired length at the score marks.
3. Reassemble the hangar bars once you have adjusted the length to your desired size.
4. Position the frame between the joists, ensuring that the hangar bars are in the correct position. The bottom edge of the hangar bars should be level with the bottom of the joists.
5. Starting with the swivel foot end of the hangar bar, secure the hangar bars to the joists using the captive nails provided.
6. Lift and secure the opposite side of the frame to a ceiling joist.
7. Position the frame in the desired place on the hangar bars and tighten the set xxxx to lock the frame in place.
Please note that it is important to turn off the power before starting the installation process, and this product should only be used on 120VAC, 60Hz circuits. Additionally, this frame is designed for use with the NICOR DLRvS retrofit downlight only.
For more detailed instructions and illustrations, please refer to the NICOR DLR56 (v5) 5-6-inch White Recessed LED Downlight System Instruction Manual provided with the product.
Add New Comment