User Manual Q&AAnswer
Feb 23, 2025 - 08:56 PM
To connect your speakers to the Behringer A800 Power Amplifier, you have two options: using the binding post outputs or the twist-locking speaker outputs.
1. Using the binding post outputs:
a. Strip the ends of your speaker cables to expose the bare wire.
b. Loosen the binding post screws on the back of the amplifier.
c. Insert the bare wire into the corresponding binding post terminals (red for positive, black for negative).
d. Tighten the screws to secure the connection.
2. Using the twist-locking speaker outputs:
a. Use high-quality professional speaker cables with twist-locking plugs pre-installed.
b. Align the plug with the speaker output jack on the amplifier.
c. Insert the plug into the jack and twist it clockwise until it locks into place.
Please note that you should always power off the A800 using the POWER switch before connecting or disconnecting speakers. This will help prevent any potential damage to the amplifier or speakers. For more detailed information, refer to the "Step 1: Hook-Up" section in the Behringer A800 User Guide.
Add New Comment