Answer

Feb 23, 2025 - 08:37 PM
To install the KRAMER K-POD303 Desk and Table Mounting Enclosure, follow these steps:
1. Familiarize yourself with the K-POD303 features and components, such as the blank inserts, insert openings, frame, Decora opening, front panel, attachment xxxx openings, table xxxx openings, cable opening, and enclosure.
2. Disassemble the K-POD303 by removing the four attachment screws, the frame, and the enclosure frame. If necessary, remove the blank inserts from the frame.
3. If you plan to pass the cables below the table, drill a hole in the table with a diameter of 30mm (1.2") in the desired location. Take care not to damage the table.
4. Place the K-POD303 on the table surface, aligning the underside opening with the drilled hole (if applicable). Use the supplied 4x1/2" screws to attach the K-POD303 to the table's surface by passing them through the table xxxx openings and tightening them.
5. Connect the Kramer Decora product to the rear of the frame using the screws provided by the Decora product manufacturer. Remove any blank inserts from the frame and install the necessary inserts.
6. Pass the cables through the enclosure's cable opening. Align the enclosure frame holes with the enclosure xxxx openings. Position the frame over the front panel and secure them together to the enclosure attachment xxxx openings using the supplied screws.
Please refer to the KRAMER K-POD303 Desk and Table Mounting Enclosure Instruction Manual for more detailed instructions and illustrations.
Add New Comment