How do I unpair my SatelliteGuys 40.0 remote control manually? (SatelliteGuys Unpair 40.0 remote control User Manual)

Answer

manuals.plus

Feb 23, 2025 - 09:23 AM


To manually unpair your SatelliteGuys 40.0 remote control, please follow these steps:

1. Press and hold the SAT mode button until all mode buttons light up.
2. Press and hold the RECALL and 0 buttons simultaneously for 3 seconds.
3. Press the SEARCH button.
4. Press the VOL+ button.
5. Press the STOP button.

If the unpairing process is successful, you will hear three descending tones. Please wait for 5 seconds after the tones.

Note: This unpairing method is specifically for the SatelliteGuys 40.0 remote control.

If you have a different remote control model, such as the 50.0, 52.0, or 54.0, the unpairing process is slightly different. Please refer to the user manual for the specific instructions for your remote control model.

For the SatelliteGuys 50.0, 52.0, and 54.0 remote control models, follow these steps to unpair:

1. Press the System info button on the front panel of the Hopper.
2. Press and hold the SAT mode button until all mode lights on the top of the remote control light up, then release the button.
3. Press and hold the HOME and GUIDE buttons simultaneously for about 10 seconds until you hear three descending tones, indicating successful unpairing.

Please note that these instructions are based on the provided user manual. If you encounter any issues or need further assistance, it is recommended to consult the official user manual or contact the manufacturer's customer support for additional guidance.