User Manual Q&AAnswer
Feb 23, 2025 - 04:31 AM
Installing and using the Mills S83-4033 Wheel Set for Vacuum Slab Power Lifter is a straightforward process. Here are the steps to follow:
1. Ensure that the Vacuum Slab Power Lifter (model S00-2697) is turned off and disconnected from any power source before proceeding with the installation.
2. Locate the two solid rubber tires included in the wheel set. These tires will be used to carry the load and enable single-operator use of the Vacuum Slab Power Lifter.
3. Align the wheel set with the Vacuum Slab Power Lifter by positioning the tires on either side of the lifter. Make sure that the tires are facing the correct direction and that the mounting brackets align with the designated slots on the lifter.
4. Once aligned, firmly push the wheel set onto the lifter until it securely locks into place. You may need to apply some force to ensure a tight fit.
5. After the wheel set is mounted, double-check that it is securely attached to the Vacuum Slab Power Lifter by giving it a gentle tug or shake.
6. Once the wheel set is properly installed, you can now use the Vacuum Slab Power Lifter as a single-operator trolley. Simply push the unit along, and the two solid rubber tires will carry the load.
7. When you have finished using the Vacuum Slab Power Lifter with the wheel set, you can remove the wheels by reversing the installation process. Ensure that the lifter is turned off and disconnected from any power source before removing the wheel set.
Please refer to the Mills S83-4033 Wheel Set for Vacuum Slab Power Lifter User Manual for more detailed instructions and safety guidelines.
Add New Comment