User Manual Q&AAnswer
Feb 22, 2025 - 09:40 AM
To assemble the GARDENA 1254 Irrigation Valve Box, please follow these steps:
1. Grease all O-rings and metal securing clips with the accompanying silicone grease.
2. The distributor (C) has three connections. xxxx end caps (D) onto the unused distributor inputs.
3. Insert the distributor and connections (G) and secure them with the nuts (E). Fit the drain cap (F).
4. Insert the long telescopic pipe (I) into the connection on the outlet side (securing clip facing upwards).
5. xxxx the short telescopic pipe (J) into the input side of the valve. Arrows on the valve show the direction of flow.
6. Insert the valve with the short telescopic pipe into the input side of the box.
7. xxxx the long telescopic pipe (I) into the outlet side of the valve (I).
8. Press down the securing clips. If necessary, xxxx in the telescopic pipes until the clips move down without much resistance.
9. Insert a short telescopic pipe (J) into the open distributor outlet on any channels that are not needed.
10. Underlay the valve box with a pack of coarse gravel and set it in place so that it is level with the turf.
11. If connecting multiple valve boxes, use suitable connectors as illustrated in the manual.
12. Insert the terminal strip (N) into the bracket.
13. Follow the instructions in the manual for connecting the valves and water control unit using the provided cables.
14. Press the protective cap (O) over the terminal strip (N) and secure it using the two screws (M).
Please refer to the manual for detailed illustrations and additional information on the assembly process.
Add New Comment