User Manual Q&AAnswer
Feb 22, 2025 - 08:50 AM
To connect the PYLE PCS2X4 Center Channel Speaker to your audio amplifier, follow these steps:
1. Ensure that your amplifier is turned off and unplugged from the power source.
2. Identify the speaker wire terminals on the back of the speaker. There should be two terminals, one labeled "+" (positive) and one labeled "-" (negative).
3. Strip the insulation from the ends of your speaker wire to expose the bare wire.
4. Insert the bare wire into the corresponding terminals on the speaker. The positive wire should be connected to the "+" terminal, and the negative wire should be connected to the "-" terminal.
5. Tighten the terminals to secure the wire in place. Ensure that there is a secure connection and no loose wires.
6. Repeat the above steps for the other speaker if you are connecting a stereo setup.
7. Locate the speaker output terminals on your audio amplifier. These terminals may be labeled as "Speaker Out" or "Speaker Output."
8. Connect the other end of the speaker wire to the corresponding terminals on the amplifier. Again, ensure that the positive wire is connected to the positive terminal and the negative wire is connected to the negative terminal.
9. Tighten the terminals on the amplifier to secure the connection.
10. Double-check all connections to ensure they are secure and properly matched.
11. Once all connections are made, you can turn on your audio amplifier and adjust the volume accordingly.
Note: It is important to check the amplifier's power output and ensure that it does not exceed the maximum input power of the PYLE PCS2X4 Center Channel Speaker. Using an amplifier with a higher power output may damage the speakers. The PCS2X4 is compatible with 4- or 8-ohm audio amplifiers.
For further assistance or troubleshooting, you can contact PYLE's customer support at (1) 718-535-1800 or email support@pyleusa.com.
Add New Comment