Answer

Feb 22, 2025 - 07:00 AM
To mount the Welch Allyn SureTemp Plus 690 Thermometer to a wall surface, follow these steps:
1. Select the appropriate mounting hardware for the type of wall surface you are attaching the WALL HOLDER to. Welch Allyn recommends consulting a professional service for installation if you are unsure about the hardware to use.
2. Position the WALL HOLDER on the wall surface approximately 122 cm (48 inches) from the floor. Ensure there is a clearance of at least 30.5 cm (12 inches) on the top and 10.25 cm (4 inches) on each side and bottom.
3. You can choose to use either the double-sided adhesive tape provided or four #8 screws (not provided) to secure the WALL HOLDER. If using screws, use the template provided to locate the WALL HOLDER onto the wall surface.
4. Pre-set screws into the wall at target points A & B shown on the template. Make sure the screws fit tightly into the wall. Then, assemble the WALL HOLDER onto these screws.
5. After assembling the WALL HOLDER to the wall surface, complete the installation by properly setting screws into target points C & D.
Note: When theft protection is a concern, it is recommended to mount the WALL HOLDER with screws rather than using double-sided tape, as it does not provide adequate theft security for the thermometer.
For further assistance, please refer to the Welch Allyn SureTemp Plus 690 Thermometer instructions manual.
Add New Comment