User Manual Q&AAnswer
Feb 22, 2025 - 03:18 AM
To connect your pedals to the Radial EXTC-SA Reamp Effects Reamper, you will use the unbalanced high impedance ¼” LOOP-A & B jacks. Here are the steps:
1. Start by turning off your audio system and turning all volume levels down.
2. Connect the +4dB output from your recorder to the balanced INPUT on the rear panel of the EXTC-SA.
3. Connect the high-Z ¼” SEND jack of the EXTC-SA to the input of your first pedal in the pedal chain.
4. Connect the output of your last pedal in the chain to the RECV jack of the EXTC-SA.
5. To send the processed signal back to your recording system, connect the balanced EXTC-SA output (XLR or ¼” TRS) to your recording system and route the signal to a new track.
It is recommended to start with one pedal patched into LOOP-A before connecting more pedals to LOOP-B. This will make it easier to troubleshoot when first setting up the EXTC-SA.
Please refer to the user guide for more detailed instructions and illustrations on connecting your pedals to the EXTC-SA Reamp Effects Reamper.
Add New Comment