User Manual Q&AAnswer
Feb 22, 2025 - 02:56 AM
To install additional fans in the Sharkoon VG6-W Black Mid Tower Case, please follow these steps:
1. Determine the desired location for the additional fans. The case supports two 120mm fans on the front panel and one 120mm fan on the rear panel.
2. For the front panel fans, remove the front panel by gently pulling it towards you. This will expose the fan mounting area.
3. Attach the additional 120mm fans to the front panel by aligning the xxxx holes on the fans with the corresponding holes on the case. Secure the fans in place using screws.
4. Connect the fan cables to the appropriate fan headers on your motherboard or fan controller.
5. For the rear panel fan, locate the fan mounting area on the rear of the case.
6. Attach the additional 120mm fan to the rear panel by aligning the xxxx holes on the fan with the corresponding holes on the case. Secure the fan in place using screws.
7. Connect the fan cable to the appropriate fan header on your motherboard or fan controller.
8. Once the additional fans are installed, replace the front panel by aligning the tabs on the panel with the slots on the case. Gently push the panel back into place until it clicks.
9. Ensure that all fan cables are properly connected and routed to avoid any interference with other components.
10. Power on your system and check if the additional fans are functioning properly.
Please refer to the Sharkoon VG6-W Black Mid Tower Case Instruction Manual for more detailed instructions and illustrations.
Add New Comment