User Manual Q&AAnswer
Feb 21, 2025 - 11:55 PM
To pair the SUPERLED SR-ZG9100A-S ZigBee In Wall Smart Switch with your ZigBee network, you can follow these steps:
1. Remove the device from any previous ZigBee network it may have been added to. You can do this by performing a factory reset manually. Refer to the user manual for instructions on how to do this.
2. From your ZigBee controller or hub interface, choose to add a lighting device and enter pairing mode as instructed by the controller.
3. If you want to pair the switch with a ZigBee remote, you can use the Touchlink commissioning method. There are two methods you can use:
- Method 1: Short press the "Reset" button on the switch (or re-power on the device) four times to start Touchlink commissioning immediately. Repeat the operation within 180 seconds if needed.
- Method 2: Re-power on the device, and Touchlink commissioning will start after 15 seconds if it's not added to a ZigBee network yet. Repeat the operation within 165 seconds if needed. If the device is already added to a network, Touchlink commissioning will start immediately within 180 seconds.
4. Once the pairing process is successful, the device will be added to your ZigBee network and can be controlled by the linked remotes or your ZigBee controller.
Please note that these instructions are a general guide, and it's always recommended to refer to the user manual for specific instructions and additional information.
Add New Comment