Answer

Feb 21, 2025 - 11:45 PM
To set up the E-Lock security code on your Sanctuary SA-PS1D floor safe, follow these steps:
1. Locate and remove the red cap covering the reset button on the inside of the door panel.
2. Push the reset button to begin the process of setting your own unique entry code. You will hear one beep and see one green light flash.
3. Input your new 3-8 digit code within 3 seconds. Each input will result in one beep and one green light flash.
4. Press the "LOCK" button to confirm. You will hear two beeps and see a flashing green light, indicating that the new code was successfully set.
5. If the red light flashes twice and beeps, it means the code failed. Press the reset button again and repeat the code programming sequence.
Note: It is important to choose a security code that you can remember easily but is not easily guessable by others. Avoid using simple combinations like "1234" or repetitive numbers like "1111".
If you have any further questions or need assistance, please contact Customer Service at cs@saproducts.com or (888) 792-4264.
Add New Comment