Answer

Feb 21, 2025 - 11:41 PM
To connect the GOBOS 041901 Moving Head Boreal 450 Zoom to a DMX controller, you will need a shielded twisted-pair cable designed for RS-485 and 3-pin or 5-pin XLR plugs and connectors. Follow these steps:
1. Locate the DMX output of your DMX controller and the DMX input of the moving head fixture.
2. Connect one end of the cable to the DMX output of the controller and the other end to the DMX input of the fixture.
3. If you are connecting multiple fixtures in a chain, connect the DMX output of the first fixture to the DMX input of the next fixture, and so on.
4. Make sure the DMX cable path is as short as possible for proper data transmission.
5. Terminate the DMX chain with a terminator at the last fixture. Solder a 120Ω resistor between Signal (-) and Signal (+) into a 3-pin XLR plug and plug it into the DMX output of the last fixture.
By following these steps, you will be able to control the GOBOS 041901 Moving Head Boreal 450 Zoom using a DMX controller.
Add New Comment