User Manual Q&AAnswer
Feb 21, 2025 - 11:09 PM
To connect your loudspeakers to the AUDIBAX Zone 120BT amplifier, you will need to use the euro terminal block connectors on the back panel of the device. The type of connection will depend on whether you are using low impedance or constant voltage speakers.
For low impedance speakers (4 ohm), you will connect the positive terminal of the speaker to the positive terminal of the amplifier and the negative terminal of the speaker to the COM (ground) terminal of the amplifier. Make sure to use the 4-pin terminal block connectors for low impedance speakers.
For constant voltage (100V/70V) speakers, you will connect the positive output of the amplifier to the positive terminal of the speakers, and the negative terminal of the speakers to the COM (ground) terminal of the amplifier. Use the 4-pin terminal block connectors on the right side of the euro terminal block for constant voltage speakers.
It is important to note that you can only use one type of speaker (either low impedance or constant voltage) at a time. Make sure to select the appropriate output option based on your speaker type.
For more detailed instructions and illustrations, please refer to the "Connecting the loudspeakers" section in the AUDIBAX Zone 120BT User Manual.
Add New Comment