User Manual Q&AAnswer
Feb 21, 2025 - 10:35 PM
To change the chisel on the SEALEY SA613.V2 Medium Stroke Composite Air Hammer Kit, follow these steps:
1. Disconnect the hammer from the air supply before changing accessories or performing any maintenance.
2. Insert the chisel shank into the gun cylinder.
3. Place the retainer ring over the chisel and lower it onto the hammer's cylinder thread.
4. Wind the retainer spring onto the cylinder using a clockwise motion until the spring is fully located and the chisel is retained by the spring's retaining tag.
5. To remove the attachment, reverse the procedures mentioned above.
Please refer to Section 4.1 and 4.2 of the instruction manual for more detailed instructions and illustrations. Remember to always follow safety precautions and wear appropriate protective gear when using the air hammer.
Add New Comment