User Manual Q&AAnswer
Feb 21, 2025 - 08:53 PM
To install the PIR Motion Sensor for the WiTi Anti-Theft System, follow these steps:
1. Choose a suitable location inside the caravan or trailer, facing North/South, so that it can detect movement along the length of the van.
2. Avoid installing the PIR near air conditioning units, heat sources (oven/extractor fan), or in areas that receive direct sunlight.
3. Mount the PIR at a height of approximately 2.2m above the floor.
4. Turn on the sensor using the switch on the side of the unit. The LED will flash briefly, and the sensor will run a self-test for about 30 seconds before entering normal operating mode.
5. When the alarm is armed, the PIR will send a signal to the WiTi Anti-Theft System if movement is detected, triggering the alarm.
Please refer to the installation guide for more detailed instructions and illustrations.
Note: Additional PIR Motion Sensors and Magnetic Door Switches can be purchased separately and added to your existing system by following the programming instructions provided in the manual.
Add New Comment