User Manual Q&AAnswer
Feb 21, 2025 - 07:38 AM
To install and set up the UBIQUITI NBE-5AC-16 NanoBeam, please follow the instructions below:
1. Safety Precautions:
- Read and follow all safety notices and warnings provided in the manual.
- Ensure proper ventilation by keeping at least 20 mm of clearance next to the ventilation holes for adequate airflow.
- Avoid exposing the product to rain, moisture, or submerging it in water.
- Do not use the product during an electrical storm.
2. Electrical Safety:
- Ensure compliance with voltage, frequency, and current requirements indicated on the manufacturer's label.
- Only use the provided approved power cord and never use an adapter plug that eliminates the grounding wire.
- The equipment requires the use of the ground wire for safety certification, so do not modify or misuse it.
- If you have any installation questions, consult a qualified electrician or contact the manufacturer.
3. Radiation Exposure:
- Maintain a minimum distance of 20 cm between the radiator of the device and your body.
- Do not co-locate or operate the transmitter in conjunction with any other antenna or transmitter.
4. Operating Frequency and RF Output Power:
- The operating frequency ranges are 5150-5350 MHz, 5470-5725 MHz, and 5725-5875 MHz.
- The maximum RF output power varies depending on the frequency range: 23 dBm, 30 dBm, and 36 dBm.
5. Declaration of Conformity:
- The UBIQUITI NBE-5AC-16 NanoBeam is in compliance with the essential requirements and provisions of Directives 2014/53/EU, 2014/30/EU, and 2014/35/EU.
- The device's software does not affect its conformity with the RED, even if the software is changed or replaced.
For detailed installation and setup instructions, please refer to the complete manual available at the following internet address: ui.com/compliance.
Add New Comment