How do I install the Fisher & Paykel AHP3RDB19 Round Flush Handle Kit for Integrated Refrigerator Freezer? (FISHER & PAYKEL AHP3RDB19 Handle Kit Refrigerator Freezer User Guide)

Answer

manuals.plus

Feb 21, 2025 - 07:11 AM

Installing the Fisher & Paykel AHP3RDB19 Professional Round Flush Handle Kit for Integrated Refrigerator Freezer is a relatively straightforward process. Here are the steps to follow:

1. Start by gathering all the necessary tools and equipment for the installation, including a screwdriver and a measuring tape.

2. Ensure that the refrigerator and freezer doors are closed and secure.

3. Measure and mark the desired height for the handle on both the refrigerator and freezer doors. The height should be 500mm for the refrigerator door and 270mm for the freezer door.

4. Using a screwdriver, remove any existing handles or hardware from the doors.

5. Take the Fisher & Paykel AHP3RDB19 handle kit and align it with the marked height on the doors. Ensure that the handle is centered and level.

6. Insert the provided screws through the handle and into the pre-drilled holes on the doors. Tighten the screws securely but avoid over-tightening.

7. Repeat the process for the other door, if applicable.

8. Once the handle is securely attached to both doors, double-check its alignment and make any necessary adjustments.

9. Clean the handle and doors with a mild detergent and a soft cloth to remove any fingerprints or smudges.

10. Congratulations! You have successfully installed the Fisher & Paykel AHP3RDB19 Professional Round Flush Handle Kit for Integrated Refrigerator Freezer.

Please note that these instructions are a general guide and may vary slightly depending on your specific model. For detailed and model-specific instructions, it is always recommended to refer to the user guide or contact Fisher & Paykel's Customer Care Centre for assistance.