User Manual Q&AAnswer
Feb 21, 2025 - 05:33 AM
Sure! Here are the step-by-step instructions for installing the MAPerformance MAP EVOX-PSR Power Steering Reservoir:
Step 1: Start by removing the two 10mm bolts that are holding the factory power steering reservoir to your vehicle.
Step 2: Once the bolts are removed, detach the upper power steering reservoir hose from the reservoir. If you have a fluid suction pump, this is a good time to remove as much power steering fluid from the reservoir as possible.
Step 3: Move the reservoir to the side and remove the lower hose.
Step 4: Attach the lower hose to the MAP EVOX power steering reservoir.
Step 5: Attach the upper hose to the MAP EVOX power steering reservoir.
Step 6: Securely mount the MAP EVOX PSR to the factory reservoir mounting bracket using the included 5mm Allen head bolts.
Step 7: Fill the MAP EVOX PSR with power steering fluid up to the halfway point in the sight glass. It is important to start the car, move the steering wheel side to side a few times, and then recheck the fluid level to ensure the system is properly filled.
That's it! Your MAPerformance MAP EVOX-PSR Power Steering Reservoir should now be installed and ready to use. If you have any further questions or concerns, don't hesitate to reach out to MAPerformance's customer support team at 1-888-627-3736 or via email at support@maperformance.com. You can also connect with them on social media through their Facebook page at www.facebook.com/modernautomotiveperformance/.
Add New Comment