How do I install the Lucci decor 010277 Elliot Small Squat 205mm Pendant in Black? (Lucci decor 010277 Elliot Small Squat 205mm Pendant Instruction Manual)

Answer

manuals.plus

Feb 21, 2025 - 03:02 AM

To install the Lucci decor 010277 Elliot Small Squat 205mm Pendant in Black, please follow these steps:

1. Ensure that the installation is done by a licensed electrician and that all wiring and installation adhere to local and national wiring rules.
2. Select a suitable location for installation, keeping in mind that this product is suitable for indoor use only.
3. Make sure the mounting point can support 2 times the weight of the fitting.
4. Ensure that the fitting is not installed in direct line of an air vent/system and is not placed in any moist or damp areas.
5. Lay out all the components on a smooth surface and check for any missing parts. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
6. Check whether the fitting has been damaged during transport. Do not install any product that appears damaged. Return it to the place of purchase for inspection, repair, or replacement.
7. Ensure that power to the circuit you are working on has been switched OFF before commencing any electrical work.
8. Remove all packaging material from the product, being careful not to throw away any hidden accessories.
9. Decide on the suspension length for your fitting by adjusting the cord anchorage.
10. Attach the screws, washers, and nuts onto the mounting bracket.
11. Use the mounting bracket as a template to mark the xxxx positions on the ceiling.
12. Install the mounting bracket onto the ceiling using appropriately sized mounting screws, washers, and anchors.
13. Remove the cover from the terminal block and connect the mains supply wire following the provided color coding.
14. Ensure the wires are secure and no bare wires are exposed. Install the cover back over the terminal block.
15. Install the canopy onto the mounting bracket and secure it with the decorative nuts.
16. Install a suitable globe into the lamp holder, making sure not to exceed the maximum wattage rating.
17. After the installation, switch on the fitting to test and enjoy your new lighting product.

Please refer to the instruction manual for more detailed information and illustrations.