How do I set up the hygger HG042 Aquarium Inverter Wave Maker Pump? (hygger HG042 Aquarium Inverter Wave Maker Pump User Manual)

Answer

manuals.plus

Feb 21, 2025 - 02:58 AM

To set up the hygger HG042 Aquarium Inverter Wave Maker Pump, please follow these steps:

1. Install the wave maker pump in your fish tank.
2. Align the metal connector and connect the wave pump wires to the controller.
3. Power on the wave maker pump.
4. Press the wifi/feed key on the controller to select the control type: Wi:N (Solo Mode), Wi:M (Lead Mode), or Wi:S (Follow Mode).
- In Wi:S mode, the controller is in Lead Mode and you cannot change any settings. If you have more than two controllers, you can set one to Wi:S and the other to Wi:M. The Lead Mode controller will control the Follow Mode, and both devices will make waves simultaneously. If you have only one controller, you can choose Wi:N or Wi:M.
5. Press the first button mode to select one of the 6 wave-making modes (M1 ~ M6).
6. Press the second button FRE/ME to adjust the frequency size (01 ~ 99 grades).
7. Press the third button FL/LIGHT to select the flow rate (01 ~ 20 gears). Long press this button for 3 seconds to turn on or off the light control mode.
8. To stop making waves and feeding, press and hold the wifi/feed key for three seconds. The wave maker pump will automatically stop for ten minutes to feed. To exit feeding mode, press and hold the wifi/feed key for three seconds.
9. The LCD screen will go out if there is no operation within 30 seconds. Press any button to make the screen light up again.

Please refer to the user manual for more detailed instructions and information on the different modes and settings of the hygger HG042 Aquarium Inverter Wave Maker Pump.