How do I install the YPHIX Built-in LED Spotlight Verona Round Aluminum Tiltable? (YPHIX Built-In LED Spotlight verona Round Aluminum Tiltable Instruction Manual)

Answer

manuals.plus

Feb 21, 2025 - 02:09 AM


To install the YPHIX 50114401 Built-in LED Spotlight Verona Round Aluminum Tiltable, please follow the instructions provided in the installation manual. Here is a step-by-step guide:

1. Start by turning off the power supply to the installation area to ensure safety.

2. Determine the desired location for the spotlight and mark the spot on the ceiling or wall.

3. Use a suitable drill bit to create a hole in the marked spot. The hole size should match the dimensions specified in the manual.

4. Insert the spotlight into the hole and secure it using the provided mounting clips or screws. Make sure the spotlight is properly aligned and flush with the surface.

5. Connect the wiring according to the electrical regulations and standards in your area. It is recommended to consult a qualified electrician for this step if you are not familiar with electrical installations.

6. Once the wiring is connected, carefully push the spotlight into the hole until it is fully inserted. Ensure that the spotlight is securely held in place.

7. Adjust the tilt angle of the spotlight to the desired position. The YPHIX 50114401 Built-in LED Spotlight Verona Round Aluminum Tiltable allows for tilting to direct the light beam.

8. Finally, restore the power supply and test the spotlight to ensure it is functioning correctly.

For more detailed instructions and illustrations, please refer to the YPHIX 50114401 Built-in LED Spotlight Verona Round Aluminum Tiltable Installation Manual.