User Manual Q&AAnswer
Feb 21, 2025 - 01:35 AM
To adjust the stroke/lift of the Neptronic MM000 A and M Linear Actuators, follow these steps:
1. Apply power to the actuator and wait for the LED to turn off (approximately 10 seconds).
2. Press and release the reset button to start the auto-stroke process. The LED should illuminate.
3. When the actuator reaches the desired start position, press and release the reset button. The actuator will now move to the end position. You can also press and release the reset button when it reaches the end position. The LED will turn off, indicating that the process is complete.
By following these steps, you can adjust the stroke/lift of the Neptronic MM000 A and M Linear Actuators to your desired length. For more information and visual references, please refer to the instruction manual provided.
Add New Comment