User Manual Q&AAnswer
Feb 21, 2025 - 01:30 AM
To assemble the Roborock S7 Auto-Empty Dock, follow these steps:
1. Take the screwdriver provided and locate the five xxxx holes on the base of the dock.
2. Place the dock upside down on a soft, flat surface (such as a carpet or towel) to protect it.
3. Use the screwdriver to xxxx in the five screws into the marked areas on the base of the dock.
4. Connect the power cable to the dock and ensure that any excess cable is stored inside the cable storage slot.
5. Place the dock on a hard and flat floor, such as wood, tile, or concrete. Make sure there is at least 0.5 meters (1.6 feet) of clearance on either side, 1.5 meters (5 feet) in front, and 1 meter (3 feet) above the dock.
6. Ensure that the location where you place the dock has a good Wi-Fi signal.
7. Turn on the dock and check that the status indicator light is functioning properly.
Note: It is important to follow these assembly instructions to ensure proper functioning of the Roborock S7 Auto-Empty Dock.
Add New Comment