User Manual Q&AAnswer
Feb 21, 2025 - 01:06 AM
To light the pilot light on the LENNOX EDST Direct Vent Multi-Open Decorative Gas Fireplace, please follow the steps outlined in the instruction manual.
1. Ensure that the gas supply valve is in the "OFF" position.
2. Locate the control panel on the fireplace. Open the control panel door.
3. Locate the gas control xxxx . It should be labeled "OFF," "PILOT," and "ON."
4. Turn the gas control xxxx to the "OFF" position and wait for at least five minutes to allow any gas to dissipate.
5. After five minutes, turn the gas control xxxx to the "PILOT" position.
6. Press and hold the control xxxx in the "PILOT" position.
7. While holding the control xxxx , press the igniter button repeatedly until the pilot ignites.
8. Continue to hold the control xxxx in the "PILOT" position for about one minute to ensure the pilot stays lit.
9. After one minute, release the control xxxx and verify that the pilot flame remains lit.
10. If the pilot flame goes out, repeat steps 4 to 9.
11. Once the pilot flame is lit and stable, turn the gas control xxxx to the "ON" position.
12. Close the control panel door.
Please note that these instructions are a general guideline, and it is crucial to consult the specific instruction manual for your LENNOX EDST Direct Vent Multi-Open Decorative Gas Fireplace for accurate and detailed information.
Add New Comment